- Electronics Board & System Design: Own schematic design and component selection for all proprietary boards.
Design system-level wiring architecture and detailed technical drawings.
- Embedded Firmware Development: Write and architect low-level C/C++ firmware infrastructure
to control and interface sensors, multi-axis motors, high-precision components and lasers subsystems with the software.
- Hands-on Board Bring-Up, QC & Troubleshooting: Act as the primary lab problem solver for board debugging,
rework, and failure analysis. Establish QC procedures for newly received boards to support production.
- DFM & Cost Optimization: Apply strict Design for Manufacturability (DFM) principles to optimize PCB layouts,
streamline assembly, and aggressively reduce production and bill-of-materials (BOM) costs.
- PCB Layout Management: Drive physical board layout design,
Requirements: - Education: B.Sc. in Electrical Engineering with at least 5 years of experience
- Hardware & Layout Expertise: 3+ years of experience in board design (mixed-signal, power management, microcontrollers)
and PCB layout tools (e.g., Altium, OrCAD, KiCad).
- Embedded Firmware Skills: Strong C/C++ programming skills for microcontrollers (STM32, ARM Cortex, etc.)
and deep familiarity with hardware protocols (SPI, I2C, UART, CAN, USB).
- Hands-on Capability: Excellent lab skills (soldering, prototyping, oscilloscope diagnostics)
and a natural problem-solving mindset.
- Proven DFM Focus: Demonstrated experience implementing DFM practices specifically targeted at price reduction,
cost optimization, and yield improvement in production.
This position is open to all candidates.
מתאים גם למגזר החרדי
מתאים גם למגזר הדתי
