- Electronics Board & System Design: Own schematic design and component selection for all proprietary boards.
Design system-level wiring architecture and detailed technical drawings.
- Embedded Firmware Development: Write and architect low-level C/C++ firmware infrastructure
to control and interface sensors, multi-axis motors, high-precision components and lasers subsystems with the software.
- Hands-on Board Bring-Up, QC & Troubleshooting: Act as the primary lab problem solver for board debugging,
rework, and failure analysis. Establish QC procedures for newly received boards to support production.
- DFM & Cost Optimization: Apply strict Design for Manufacturability (DFM) principles to optimize PCB layouts,
streamline assembly, and aggressively reduce production and bill-of-materials (BOM) costs.
- PCB Layout Management: Drive physical board layout design,
Requirements: - Education: B.Sc. in Electrical Engineering with at least 5 years of experience
- Hardware & Layout Expertise: 3+ years of experience in board design (mixed-signal, power management, microcontrollers)
and PCB layout tools (e.g., Altium, OrCAD, KiCad).
- Embedded Firmware Skills: Strong C/C++ programming skills for microcontrollers (STM32, ARM Cortex, etc.)
and deep familiarity with hardware protocols (SPI, I2C, UART, CAN, USB).
- Hands-on Capability: Excellent lab skills (soldering, prototyping, oscilloscope diagnostics)
and a natural problem-solving mindset.
- Proven DFM Focus: Demonstrated experience implementing DFM practices specifically targeted at price reduction,
cost optimization, and yield improvement in production.
This position is open to all candidates.
